<div dir="ltr">Hello Everyone,<div><br></div><div>I am using the Flash 3D setup for my project. Before implementing the 3D setup to my specific problem, I am trying to run the default cases in FLASH. Once that is done, I will change the files to tailor it to my requirements.</div><div><br></div><div>One of the 3D default cases in FLASH is of the cylinder. There is a simulation block in which a cylinder is placed and the flow over the cylinder is visualized. Since this is a default case, I didn't change any files which I downloaded from FLASH website and ran as it is.</div><div><br></div><div>The simulation starts properly. But after a few time steps, the value of dt_hydro is going to a large negative value. As a result, the simulation blows up. Has anyone faced a similar problem? Any suggestions would be greatly appreciated.</div><div><br></div><div>Thank you for the time.</div><div><br clear="all"><div>Best,</div><div><br></div><div>Madhav</div>-- <br><div dir="ltr" class="gmail_signature" data-smartmail="gmail_signature"><div dir="ltr"><div style="color:rgb(34,34,34)">Best Regards,</div><div style="color:rgb(34,34,34)"><br></div><div style="color:rgb(34,34,34)">Madhav Nagori (he/him)</div><div style="color:rgb(34,34,34)"><br></div><div style="color:rgb(34,34,34)">PhD Candidate | Laboratory for Multiscale Computational Fluid Dynamics</div><div style="color:rgb(34,34,34)">Department of Mechanical Engineering and Engineering Sciences</div><div style="color:rgb(34,34,34)">University of North Carolina at Charlotte</div><div style="color:rgb(34,34,34)">Office: Duke 273, 9330 Robert D. Snyder Rd, Charlotte, NC 28262, USA</div><div style="color:rgb(34,34,34)">Email: <a href="mailto:mnagori@uncc.edu" target="_blank">mnagori@uncc.edu</a><br></div><div style="color:rgb(34,34,34)">LinkedIn: <a href="http://www.linkedin.com/in/madhav-nagori" target="_blank">www.linkedin.com/in/madhav-nagori</a></div></div></div></div></div>