[FLASH-USERS] change Eos of chamber material (LaserSlab)

[Sijoy C D]

Hi,

The EOS table "he-imx-005.cn4" of chamber material (He) must be replaced
with a similar EOS table for air.
Note that the format of this table (including opacities for each group)
must be compatible with the
FLASH EOS module (refer to the manual). Also, the initial conditions
(density, temp, etc) must be specified
as per your requirement (in geometry setup). To the best of my knowledge,
FLASH will not generate EOS for any material.
The required format for FLASH EOS module is precisely given in the manual.

Best,
*Sijoy C. D.*


On Thu, Nov 17, 2016 at 4:13 PM, phani sri <phanisri123 at gmail.com> wrote:

> Hi, I am trying to simulate the laser slab by changing the chamber
> material to air, can any one suggest how to get the air eos, can we
> generate the air eos in FLASH.
> Thank You
>
>
>
>
>
>
> --
> D. P. S. L. Kameswari,
> Ph. D Scholar (Physics)
> ACRHEM
> University Of Hyderabad,
> Hyderabad,
> e-mail:phanisri123 at gmail.com <id%3Aphanisri123 at gmail.com>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://flash.rochester.edu/pipermail/flash-users/attachments/20161117/20987a12/attachment-0001.htm>