[FLASH-USERS] Flash Users: usm solver with non cubic block size in Uniform Grid
Gandhari Wattal
gwattal at wisc.edu
Mon Feb 6 13:02:09 EST 2017
Hi
I am using the Flash4.2.2 code to run a MHD simulation. When I run this
simulation with Uniform Grid and a non cubic block size the code crashes
with the error "DRIVER_ABORT: [Hydro]: Computed dt is not positive!
Aborting!".
When I run the same code with a cubic block size in a uniform Grid, it
works fine.
I also tried the sample MHD test setup BrioWu with the usm solver.
Again the BrioWu code would crash with the non cubic block and run fine
with a cubic block. When I ran the BrioWu with the 8 wave solver it ran
fine with the non cubic block size.
I also ran the hydro test setup Sod. The Sod setup runs fine with a non
cubic grid.
So this leads me to believe that there is some problem with the usm
solver in the non cubic block size uniform grid implementation.
Any help or suggestions in this regard will be highly appreciated.
Thanks
Gandhari
--
Gandhari Wattal
Doctoral student
Department of Physics
University of Wisconsin-Madison
More information about the flash-users
mailing list