[FLASH-USERS] flash 4.6 mesh parameter problem

[Fujiiki Junpei]

Dear FLASH users,

I have been trying to run 2D-cylindrical simulation in FLASH 4.6, but I 
encountered a problem.

When I run 2D-cylindrical simulation under the conditions 
nblockx=1,nblocky=2, it's running fine.

But, when nblockx=10,nblocky=20, 2D-cylindrical simulation stop 
immediately and segmentation fault occurred.

In this case, the other mesh parameters are the same.

So, my question is,

(1) Why segmentation fault occurred when nblockx=10,nblocky=20?

(2) What should be the proper way to set up a mesh parameter in 
2D-cylindrical simulation?

Best,

Junpei

-- 
---------------------------------------------------------------
大阪大学工学研究科 電気電子情報通信工学専攻　電気工学コース 蔵満研究室所属
藤域 淳平
junpei.fujiiki at eie.eng.osaka-u.ac.jp
---------------------------------------------------------------