[FLASH-USERS] Temperature error while using PPM solver

[jeevan dahal]

Dear all,

I am trying to run simulation of  a sine wave interface by shock strength
of M 1.5. When I run my simulation using the PPM in FLASH code, I see an
alternating temperature profile on the interface of sine wave. I have
attached a picture of temperature profile to make it clear. In addition, I
see a lot of diffusion in my simulation which is around 5 times the width
of the zone even though I have turned the diffusion model to be off.

I would appreciated any insights on solving the temperature problem. In
addition, how can diffusion be reduced in a simulation?

Thanks
Regards,
Jeevan
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://flash.rochester.edu/pipermail/flash-users/attachments/20160309/b61f88b8/attachment.htm>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: temperature.png
Type: image/png
Size: 9220 bytes
Desc: not available
URL: <http://flash.rochester.edu/pipermail/flash-users/attachments/20160309/b61f88b8/attachment.png>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: flash.par
Type: application/octet-stream
Size: 1689 bytes
Desc: not available
URL: <http://flash.rochester.edu/pipermail/flash-users/attachments/20160309/b61f88b8/attachment.obj>